Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateWhy Richmond Homeowners Choose Ghost Controls Gate Repair
We provide independent Ghost Controls gate repair service in Richmond, and we work on these systems often enough to know where they fail before we open the control box. Ghost Controls runs on solar-friendly boards, linear actuators rated by stroke length, and a remote and keypad ecosystem that shows very specific symptoms when something goes wrong. We’re not affiliated with Ghost Controls and we’re not authorized by the manufacturer. We’re an independent gate specialist that services the brand across Richmond. Call (866) 942-6565. We answer 24/7.
Why Trust Richmond Gate Repair for Your Ghost Controls Gate Repair?
Our technicians have up to 12 years of experience, and Ghost Controls work is a steady part of what we do. We know the quirks of these boards: which one holds up in a humid Richmond summer, which one takes on water behind the housing gasket, and how the solar charging logic behaves through a stretch of gray days. That familiarity cuts diagnostic time. You’re not paying us to read a manual in your driveway.
We use quality parts that fit Ghost Controls equipment, including OEM-spec boards, actuators, and batteries where the housing and firmware matter, and quality aftermarket arms and batteries where the OEM part is overpriced for the same duty. Our service is warranty-safe: we don’t alter or bypass manufacturer safety systems, and we don’t strip a board to force a repair that a replacement solves.
As an independent Ghost Controls service provider, we’re clear about what we are. We’re not a dealer and this page isn’t an endorsement from the manufacturer. We’re a dedicated gate specialist – repair, electric gate repair, and installation – that happens to know Ghost Controls deeply because we work on them all over Richmond.
Styles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
Common Ghost Controls Gate Repair Problems We Fix in Richmond
These five patterns come up again and again with Ghost Controls equipment in Richmond. If one of them sounds familiar, that’s a good sign the fix is smaller than a new operator.
- Control board water intrusion and surge damage. Richmond’s heavy spring thunderstorms push water into control boxes and send surges down the line. The result is a gate that’s dead, or arms that cycle erratically with no command. The board is usually the culprit, not the motor, and a metered check tells us fast whether it’s recoverable or needs replacing.
- Lead-acid battery failure in solar setups. A gate that works fine at midday but refuses to open after a cloudy stretch or overnight is a classic solar battery symptom. The lead-acid cells in a solar setup degrade in heat and humidity, and once they’ve swollen they can’t hold a charge through the dark hours. Swapping the battery usually restores normal operation.
- Linear actuator arm binding and limit-switch drift. On tube gates, the actuator arm can bind against the gate frame, or the limit switches can drift out of position. You’ll see the arm stall halfway, reverse unexpectedly, or stop short of full travel. Re-teaching the limits and clearing the bind normally corrects it.
- Keypad and remote pairing loss after a board reset. Power bumps and board resets can wipe the receiver’s memory. The gate opens with the wall control but ignores the keypad or remote, or the receiver stops responding to some devices. Re-pairing and re-teaching restores both.
- DC motor brush wear and gearbox noise. Over years of use, the DC motor and gearbox on a linear actuator wear. A grinding or clicking sound with sluggish travel points there, and it’s worth a look before it fails outright.
A typical Ghost Controls single-swing tube-gate install starts opening halfway, reversing, or ignoring the keypad after a storm. It’s often a swollen lead-acid battery in the solar box or a control board with water intrusion, not a dead motor. A qualified local tech meters the battery and board first, checks the actuator arm for bind and limit-switch drift, then replaces the battery or board and re-teaches the limits and remotes rather than selling a whole new operator.
Ghost Controls Parts & Our Repair-vs-Replace Approach
Parts choice on Ghost Controls gear matters, and we don’t treat it as a commodity line. Where the housing and firmware matter – the control board, the actuator housing, the battery spec – we use Ghost Controls-compatible OEM-spec parts. Where the OEM part is priced well above the same duty in a quality aftermarket equivalent – some batteries and arms – we use the aftermarket and tell you why. You won’t get a “genuine parts only” upsell or a cheap generic that fails in six months.
The repair-or-replace call comes down to condition, not a sales goal. If the control box and actuators are sound, we repair. If the board is corroded through and both arms are seized, we’ll tell you plainly that replacing the affected components is the honest call. We don’t stock OEM or genuine Ghost Controls parts on a truck. What we do is source the right part for the job and install it properly. Call (866) 942-6565 for a free estimate. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday.
Our Ghost Controls Service Process – Step by Step
- 1
Diagnosis. We meter the battery and board first, then check the actuator arm for bind and limit-switch drift. On solar setups we test charging behavior through a load, not just a voltage reading at rest. On dual-swing gates we check both actuators and the control box together.
- 2
Repair or install. If it’s repair, we replace the specific failed component – board, battery, arm, or keypad receiver – with a quality part that fits. If it’s installation, we set the actuators, wire the keypad and remotes, and configure the limits for your gate’s real travel.
- 3
Test. We run the gate through a full open-close cycle, then re-teach the limits and re-pair every remote and keypad yourself so nothing is left to program later. We test the safety accessories the same way.
- 4
Warranty and documentation. We explain what was replaced, what to watch for, and how to keep the installation within the manufacturer’s warranty terms. No service-call or diagnostic fee is quoted here; the price is set per job by the written estimate, agreed before any work starts.
See the difference
Before
After
Before
After
Before
AfterGhost Controls Products We Service & Install in Richmond
We repair, service, and install the Ghost Controls lineup across Richmond, including the single-swing DIY tube-gate kits driven by a linear actuator, the dual-swing kits for double driveway gates, and the heavy-duty AXS and HS actuators that handle larger or heavier gates. We also work with the solar-compatible control box, and the keypad and remote accessory line that pairs with it.
On the repair side, we handle motor repair, battery backup replacement in solar setups, and keypad entry troubleshooting – the three things we get called for most on Ghost Controls gear. Whether your gate won’t open, won’t close, or was never installed right, we can get it running. We don’t claim to stock these products or their parts; we service and install them. If you’re weighing a new install or a full operator swap, we’ll look at your gate and give you a straight answer.
We Also Service These Brands
Ghost Controls is one brand in a broader specialty. We also service LiftMaster, Mighty Mule, DoorKing, and the full lineup our technicians are knowledgeable in. Nine brands, one specialist team – that breadth means we can diagnose your system no matter whose hardware is on the gate, and we’re not tied to selling you any one brand.
FAQs – Ghost Controls Gate Repair Service in Richmond
No. We are an independent Ghost Controls service provider. We’re not authorized, certified, or affiliated with the manufacturer, and we’re not a dealer. We work on Ghost Controls systems because they’re common on Richmond gates and we know them well.
Yes. We use Ghost Controls-compatible OEM-spec boards, actuators, and batteries where the housing and firmware matter, and quality aftermarket arms and batteries where the OEM part is overpriced for the same duty. We don’t stock OEM parts on a truck, and we don’t carry a stock of genuine Ghost Controls parts – we source the right part for the job.
Most repairs take about the length of a normal service visit: a battery, board, or limit adjustment is often done same-day, while a part that needs ordering takes longer. We don’t promise same-day on installs or operator swaps, which are measured and scheduled. The price is set per job by the written estimate, agreed before work starts.
We cover the single-swing and dual-swing kits, the heavy-duty actuators, the solar-compatible control box, and the keypad and remote accessory line. We handle motor repair, battery backup, keypad entry, control board work, and full installation. If you’re not sure which system you have, we can identify it on site.
Proper service doesn’t void a warranty, but improper work can. We keep our service within the manufacturer’s terms: we don’t bypass safety systems, we use parts that fit, and we re-teach limits and remotes the way the system expects. Call (866) 942-6565 and we’ll walk through the warranty questions before we start.
Cost depends on what failed – a battery swap, a board replacement, or an actuator arm. We give you a free estimate with a written price range for the specific part and labor, and the written estimate sets the final price. No diagnostic or service-call fee is quoted here; that’s the number you’ll see before any work begins. Call (866) 942-6565 for an exact quote – estimates are free.
Book Your Ghost Controls Service in Richmond, VA
If your Ghost Controls gate is dead after a storm, acting up on cloudy days, or ignoring the keypad, call (866) 942-6565 for a free estimate. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday. Gate-only specialists, from the control board to the hinge.
Written by the team at Richmond Gate Repair.